Figure 46: 3D navigation control
9.1.4.1 Pointer information
If you use the Select image handling control and move the mouse pointer over the
image area, some information is shown. For a 2D image, the coordinates and the
intensity value of each point are displayed. This information is useful for example when
you set the height of a region, see "Setting sensor region", page 61. For a 3D image,
the coordinates, the sensor row, and the encoder counter value of each point are
displayed.
Figure 47: Pointer information (2D image)
9.1.5 Image view options
Button Name Description
Color View image in color (various options) or grayscale.
Options Contains options for Color Range, Surface and Points, as described in this
manual.
Home Restore default settings for position and zoom.
9.1.6 Log and statistics tabs
Figure 48: Log and statistics tabs
At the bottom of the main window, there are three tabs where log messages and
statistics are available.
Log and Device log
The Log tab contains messages from the GUI, and the Device log tab contains messages
from the device.
The system assigns each log message a level, either SEVERE, WARNING, INFO or FINE.
Figure 49: Log tab
OPERATION 9
8020774/1D7Q/2022-03 | SICK O P E R A T I N G I N S T R U C T I O N S | Ranger3
55
Subject to change without notice
To Next Page
Loading...
