NOTICE
•
Never connect a powered encoder interface unit to a camera.
•
Never connect signal levels that exceed the input specification to the encoder
inputs.
Failure to follow these rules can damage the camera.
NOTE
The function of the camera is not tested and guaranteed for Power I/O cables longer
than 10 meters.
NOTE
Use only shielded cables. The shield has to be terminated at both ends of the cable.
There are two connectors on the back of the camera: Gigabit Ethernet (GigE) and Power
I/O (see figure 10, page 26).
To prepare the camera for operation, do as follows:
1. Remove the protection caps that cover the connections for Gigabit Ethernet (GigE)
and Power I/O.
2. Connect the Ethernet cable to the GigE connector on the camera. Connect the
other end of the Ethernet cable to the Network Interface Card (NIC) in the PC.
3. Connect the connecting module to the Power I/O connector on the camera.
4. Connect the unpowered voltage supply to the connecting module.
5. Connect the laser to its voltage supply.
6. Switch on the power to the system.
7.5
Electrical connections
There are two connectors and four LEDs on the back plate of Ranger3.
Figure 10: Back plate of the Ranger3 device
7 ELECTRICAL INSTALLATION
26
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/1D7Q/2022-03 | SICK
Subject to change without notice
To Next Page
Loading...
