7
Photoelectric sensor
For further information about the electrical installation, see "Electrical installation",
page 22. The pin assignment is described in "Electrical connections", page 26.
Configuration
Before the camera can be used in a machine vision system, it must be configured. This
is done by adjusting parameters in the Ranger3 Studio software until the image result
is satisfactory.
See "Features", page 92 for a list of available parameters. For detailed information
about how to edit the parameters in the user interface, see "Using the interface",
page 56.
3 GETTING STARTED
12
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/1D7Q/2022-03 | SICK
Subject to change without notice
To Next Page
Loading...
