EasyManua.ls Logo

SICK Ranger3

SICK Ranger3
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parameter Type Description Visibility Access
DeviceTemperature[DeviceTemper‐
atureSelector]
float Device temperature in degrees Celsius (C). It is meas‐
ured at the location selected by DeviceTemperatureSelec‐
tor.
Expert R
Table 10: Device control custom parameters
Parameter Type Description Visibility Access
DeviceLinkThroughputCurrent int An approximation of the bandwidth required for the cur‐
rent configuration. This only includes the actual image
data, and does not include the overhead of transmis‐
sion.
Guru R
DeviceRegistersStreamingActive bool True if a registers streaming session is active. Guru R
DeviceTemperatureMin int The minimum temperature ever in degrees Celsius (C)
measured at the location selected by DeviceTempera‐
tureSelector.
Expert R
DeviceTemperatureMax int The maximum temperature ever in degrees Celsius (C)
measured at the location selected by DeviceTempera‐
tureSelector.
Expert R
DeviceCurrentBootPath enum The booted software path, i.e., bootloader, kernel, appli‐
cation etc. Primary is the normal path and Secondary is
used for rescue purposes if the primary path fails.
Values:
Primary
Secondary
Expert R
DeviceNextBootPath enum The boot path that will be used after the next soft
reset
1
. This is normally set to secondary to boot the
rescue version of the system if an unexpected reset
occurs.
Values:
Unknown
Primary
Secondary
Guru R
DeviceBootCount int Accumulated number of times the device has been
booted.
Beginner R
DeviceOperationTime int Accumulated operation time of the device, in seconds. Beginner R
1
A soft reset is an unwanted re-boot of the device.
Table 11: Device control standard SFNC commands
Command Description Visibility Access
DeviceReset Resets the device to its power up state. Guru W
DeviceRegistersStreamingStart Prepare the device for registers streaming without
checking for consistency.
DeviceRegistersStreaming is used when loading and
saving a device's configuration to/from file on the host.
Guru W
DeviceRegistersStreamingEnd Announce the end of registers streaming.
After this command DeviceRegistersValid is updated to
reflect the status of the device settings.
Guru W
16 ANNEX
94
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/1D7Q/2022-03 | SICK
Subject to change without notice

Table of Contents

Other manuals for SICK Ranger3

Related product manuals