Practical example
7.2 SGLAN example
CIM
Operating Manual, 11/2022, A5E51250518-AC
103
6. Write down the Server IP address. You will need it to configure the client.
7. Set the "Access password" and confirm it in "Confirm access password".
Write down the access password. You will need it to configure the client.
Setting up the SGLAN client
1. Access the web-based configuration (Page 45) of CIM as SGLAN client.
2. Check the cellular status.
3. Go to the SGLAN page and enable "CIM as SGLAN Client".
4. Select the remote host mode as IPv6.
Note: make sure you select the match mode to the CIM server.
5. Enter the information of server in the input box next to "Remote Host".
– If you select "IPv6", enter the Server IPv6 address of the server.
– If you select "SMS_v6", enter the phone number of the server.
Note: make sure the SIM card contains SMS if you select "SMS_v6".
To Next Page
Loading...
