Configuration
31
Building Technologies A6V10265083_a_en_--
Fire Safety & Security Products 03.2010
Set user functions to factory default settings
The user functions of all programming steps can be set to factory default values
with one operation.
1. Disconnect mains and battery
2. Press and hold numeric keys (7) 1, 2, 3, 4 simultaneously followed by reconnect-
ing mains
– LED block (1) starts flashing
3. Release numeric keys (7)
4. Press numeric keys (7) 1, 2, 3, 4 simultaneously again
– LED block (1) stops flashing and double beep of buzzer occurs
– System is now set to default
5. Reconnect battery
Note:
For factory default settings
see under Log sheet for programmed user functions
To Next Page
Loading...
Need help?
General
