NCU/NX Terminal Assignment
3.3 Macros for commissioning
Guide for the SINUMERIK 840D sl machine configuring
3-2 Manual, 07/2006 Edition, 6FC5397-6CP10-0BA0
3.3 3.3 Macros for commissioning
Introduction
To commission the drives, the following macro types are available:
● Update macro 150399
This macro executes an update of all drive components.
● Macro for infeed (Line Module) with DRIVE-CLiQ -> "1"
● Macro for infeed (Line Module) without DRIVE-CLiQ -> "5"
● Macros 100116 for preassigning the data sets and message-frame types
To Next Page
Loading...
Need help?
General
