Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
195
Figure 4-83 VLAN Priority Remap Configuration
This read-only box displays the port number to which the information on this page relates.
Priority with which a frame is received.
Priority with which a frame will be sent.
Syntax of the Command Line Interface
Table 4- 60 VLAN Port Priority Mapping - CLI\SWITCH\VLAN\PRIO>
info Shows the priority with which a port sends
received frames.
-
remap [port] [<0..7><0..7>] Changes the priority of received frames for
Administrator only.
reset Resets the priority of received frames. The
priority when receiving then corresponds to
the priority when sending.
Administrator only.
vprio <VID> [noforce | <0-7>] Changes the priority of received frames de-
pending on the VLAN to which they belong.
The frames are sent with this changed priori-
ty.
In the basic status "noforce", the priority of
the frames remains unchanged.
Administrator only.
To Next Page
Loading...
Need help?
General