Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
132 Configuration Manual, 10/2014, C79000-G8976-C187-22
The Switch menu
Introduction
In this menu, you set the parameters for the switch functionality (assign it to layer 2) of the IE
switch. This includes the following functions:
● General switch settings such as mirroring, aging, and flow control.
● The filter table for unicast, multicast and broadcast frames.
● The management of multicast groups with IGMP/GMRP.
● The use of the spanning tree protocol.
● Configuration of VLANs and their dynamic configuration with GVRP frames.
● Specifying transfer priorities with CoS to Queue and DSCP to Queue Mapping.
● DCP port filter
● Topology diagnostics with LLDP
● IP address initialization with DHCP relay
● Loop detection
● 1:1 NAT
● Statistics counter for frames per port
To Next Page
Loading...
