Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
192 Configuration Manual, 10/2014, C79000-G8976-C187-22
GVRP Configuration
Enabling GVRP functionality
With a GVRP frame, an end node or switch can register for a specific VID at a port of the IE
switch. You can enable each port for GVRP functionality on the GVRP Configuration page.
Figure 4-80 GVRP Configuration
If you select an option, the IE switch allows the registration of a VLAN by GVRP frames at
the relevant port. The IE switch can also send GVRP frames via this port.
Syntax of the Command Line Interface
Table 4- 58 GVRP Configuration - CLI\SWITCH\VLAN>
gvrpport [<E|D> [ports]] Enables/disables dynamic registration of VLANs with
GVRP for the specified ports.
Administrator only.
To Next Page
Loading...
