Siemens SCALANCE X-400 - Page 204

Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
204 Configuration Manual, 10/2014, C79000-G8976-C187-22
Command
Description
Comment
admedge [<T|F> [ports]] Specifies whether a
• T
End device
or a
• F
switch
is connected to this port that supports
Spanning Tree or Rapid Spanning Tree.
If a (rapid) spanning tree protocol is
received, the value F is displayed.
autoedge [<T|F> [ports]] Specifies whether at this port it should
be automatically detected whether a
• T
End device
or a
• F
switch
is connected.
Administrator only.
ptp [<A|T|F> [ports]] The point-to-point link establishes a
direct link between two switches.
In this case, you have the following
options:
• A
The port recognizes a PtP port
based on the duplexity. If the con-
nection is full duplex, it is assumed
to be PtP, if it is half duplex, no PtP
connection is assumed (shared me-
dium).
• T
Specifies a PtP link, even though
half duplex is being used.
• F
Specifies that there is no PtP link
over the relevant port even with full
duplex.
-