Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
251
The POF port to be tested is specified here.
The following is displayed depending on the selection:
● Name (read only)
The name of the POF port
● Model (read only)
The POF module used
● Serial (read-only)
The serial number of the POF module
The table is structured so that the latest (Current), the lowest (Low) and the highest (High)
value is always shown for the following parameters.
(read only)
The temperature of the port.
(read only)
The voltage applied to the port.
(read only)
The current with which a device connected to this port is supplied.
(read only)
The received power of the port.
(read only)
The transmit power of the port.
Syntax of the Command Line Interface
Table 4- 78 SFPDIAGNOSTIC - CLI\SWITCH\PORTDIAG\POFDIAG>
Tests the specified POF port.
To Next Page
Loading...
Need help?
General