Siemens SCALANCE X-400 Configuration Manual

Configuration using Web Based Management and Command Line Interface
4.7 The Router menu (SCALANCE X414-3E)
SCALANCE X-300 / X-400
308 Configuration Manual, 10/2014, C79000-G8976-C187-22
Authentication Type
Select the authentication method of the virtual link here. You can choose between
● none: no authentication
● simple: authentication using a password
● MD5: authentication with keyed MD5 method
Key ID
Note
The "Key ID" text box is displayed only if the authentication method was set to MD5. Only
then is it possible to use sever
al keys.
Enter the key ID here with which the password will be used as the key. Since the key ID is
transferred with the protocol, the same key must be stored under the same key ID on all
neighboring routers.
Password/Confirmation
If authentication uses a password, a key is required via MD5 that can be entered here.
Syntax of the Command Line Interface
Table 4- 98 OSPFv2 Virtual Links - CLI\ROUTER\OSPF\AREAS\VLINKS>
Command
Description
Comment
info
Displays the current virtual links.
-
add<RtrID> <AreaID> [<set-
ting=value>]
Adds a new virtual link.
Possible settings:
• TD
Trans. Delay
• RI
Retrans Interval
• HI
Hello Interval
• DI
Dead Interval
-
edit <RtrID> <AreaID> [<set-
ting=value>]
Modifies a virtual link.
Possible settings:
• TD
Trans. Delay
• RI
Retrans Interval
• HI
Hello Interval
• DI
Dead Interval
-

Siemens SCALANCE X-400 Specifications

General

Brand	Siemens
Model	SCALANCE X-400
Category	Switch
Language	English