Configuration using Web Based Management and Command Line Interface
4.1 General information on Web Based Management and Command Line Interface
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
35
Starting Web Based Management and logging on
Note
For security reasons, make sure that you change the original factory
-set passwords:
User name "admin" = password "admin"
User name "user" = password "user".
Figure 4-1 Logon dialog
1. Enter the IP address or the URL of the IE switch in the address box of the Web browser.
If there is a problem-free connection to the IE switch, the logon dialog of Web Based
Management appears as shown above.
2. Enter a user name in the "User name" input box.
The following entries are possible:
– admin: With this user name, you have read and write access.
– user: With this user name, you only have read access.
– The user name stored on a RADIUS server: See sections System Passwords & Login
Mode (Page 52) and 802.1x RADIUS Configuration (Page 152).
3. Enter your password.
4. Click the "Log On" button to start the logon.
To Next Page
Loading...
Need help?
General