Configuration using Web Based Management and Command Line Interface
4.3 The X-300/X-400 menu
SCALANCE X-300 / X-400
74 Configuration Manual, 10/2014, C79000-G8976-C187-22
The observer function is optional. As default, this is disabled.
You can configure the Observer function in the "Ring Config" menu.
Errors detected by the observer are signaled by an error LED, signaling contact and
corresponding message text. This uses the message method configured for the alarm event
"Fault State Change", see section "Agent Event Configuration".
The possible message methods are e-mail, trap and/or event log table entry.
You will find a list with the message texts in Appendix D "Error messages of the SCALANCE
X-300 / X-400".
To Next Page
Loading...
Need help?
General