Siemens SENTRON PAC4200 - Operator Input Steps; Operator Input Steps in the Measured Variable Display

Operator control
8.2 Operator input steps
SENTRON PAC4200
112 Manual, 09/2008, A5E02316180B-01
8.2 Operator input steps
8.2.1 Operator input steps in the measured variable display
Selecting the measured variable
When displaying the instantaneous value, it is possible to switch to other measured
variables.
F2
switches to the previous measured variable.
F3
switches to the next measured variable.
The order of the measured variables corresponds to the order in the main menu.
If the maximum or minimum value is displayed, F2
and F3 are not available. In
this case, switch first to the display of the instantaneous value.
Note: It is also possible to select the measured variable in the main menu.
Displaying instantaneous values, sliding window demand values, or maximum and minimum values
F1 switches the display on.
F1
: Display of the maximum value
F1
: Display of the minimum value
F1
: Display the sliding window demand
F1
: Display the maximum value of the sliding window demand
F1
: Display the minimum value of the sliding window demand
F1
: Display of the instantaneous value
Reset the maximum or minimum value to the instantaneous value
F3 resets the last reached maximum/minimum value to the instantaneous value.
Switch between import and export
F1 switches between import and export of active energy and reactive energy.
F1
: Display export.
F1
: Display of import.
Calling the "MAIN MENU"
F4 calls the menu selection. The selection bar is at the last displayed measured
variable in the menu selection.