Siemens SENTRON PAC4200 - Switch off Password Protection

Parameterizing
9.2 Parameterizing the operator interface
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
143
To switch password protection on, proceed as follows:
1. Call the "PASSWORD PROTECTION" display.
2. Activate the field "PASSWORD PROTECTION" with
F4


(1) Password protection switched OFF
(2)
Password protection switched ON
Figure 9-15 "PASSWORD PROTECTION" device setting
9.2.12.3 Switch off password protection
If password protection is switched off, there is no protection against unauthorized or
inadvertent changes to the device settings.
The currently valid password becomes visible on the display when password protection is
switched off. The password remains saved and becomes effective again the next time
password protection is switched on.
Note
Password visible on the display
The password becomes visible on the display when password protection is switched off.
To switch off password protection:
1. Call the "PASSWORD PROTECTION" display.
2. Deactivate the "PASSWORD PROTECTION" field with
F4
The device opens the "ENTER PASSWORD" dialog box.
3. Enter the password and confirm with
F4
The display returns to the "PASSWORD PROTECTION" display. The password is visible
on the display.
If you have given the correct password, password protection is switched off.
If you have given an incorrect password, password protection remains active. Start again at
Step 2 and enter the correct password.