Siemens SENTRON PAC4200 - Events; Table 3- 5 Meaning of the Symbols in the Events List

Description
3.16 Events
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
51
3.16 Events
The device reports the occurrence of certain events. These events are listed in the event
recording undertaken by SENTRON PAC. You can acknowledge acknowledgable events in
a popup window on the device.
Displaying events
Table 3- 5 Meaning of the symbols in the events list
Symbol Meaning
No symbol Information
! Warning
Alarm
Incoming event
Outgoing event
Overcurrent, overvoltage
Changed
VAR Acknowledged event
# Interrupt, error, missing
Upper limit violated, out of range
Lower limit violated
...= 0 Reset
...= 1 Condition met
The events are divided into the following event classes:
● Operating information
● System information
● Operation
The following information is shown for each event:
● Event
● Event class
● Date and time when the event occurred
● Reason why the event occurred
● Interface (if applicable)
● Measured value affected and corresponding measurement (if applicable)
● Limit value (if applicable)
● Address of the digital output (if applicable)
● Address of the digital input (if applicable)