Siemens SENTRON PAC4200 - Page 7

Table of contents
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
7
Table A- 4 Modbus Offset 203, Register 2: Limit Violations........................................................................204
Table A- 5 Overview of status and diagnostics bytes..................................................................................205
Table A- 6 Modbus offset 205, tab 2: Structure of PMD diagnostics and status.........................................205
Table A- 7 Measured variables available with a time stamp .......................................................................206
Table A- 8 Meaning of the abbreviations in the "Access" column...............................................................207
Table A- 9 Available tariff-specific measured variables...............................................................................208
Table A- 10 Meaning of the abbreviations in the "Access" column...............................................................208
Table A- 11 Available tariff-specific measured variables...............................................................................208
Table A- 12 Meaning of the abbreviations in the "Access" column...............................................................209
Table A- 13 Available measured variables: Maximum values with time stamp.............................................209
Table A- 14 Available measured variables: Minimum values with time stamp..............................................213
Table A- 15 Harmonics of the voltage ...........................................................................................................216
Table A- 16 Harmonics of the current............................................................................................................217
Table A- 17 Harmonics of the phase-to-phase voltage.................................................................................218
Table A- 18 Harmonics of the voltage ...........................................................................................................220
Table A- 19 Harmonics of the current............................................................................................................222
Table A- 20 Configuration settings ................................................................................................................224
Table A- 21 Assignment of the values 0 to 240.............................................................................................230
Table A- 22 Communication settings.............................................................................................................237
Table A- 23 Settings for the I&M data ...........................................................................................................239
Table A- 24 Commands.................................................................................................................................239
Table A- 25 MODBUS standard device identification parameters ................................................................241
Table A- 26 Errors, comments, and suggestions for improvements .............................................................242
Table C- 1 Meaning of abbreviations...........................................................................................................245
Figures
Figure 2-1
Safety-related symbols on the device..........................................................................................15
Figure 3-1 Sliding window demand ...............................................................................................................28
Figure 3-2 Maximum sliding window demand of the active power................................................................28
Figure 3-3 Load profile, fixed block method ..................................................................................................30
Figure 3-4 Load profile, rolling block method ................................................................................................31
Figure 3-5 Instantaneous and maximum values of the harmonics of the ph-ph voltage referred to the
fundamental .................................................................................................................................37
Figure 3-6 Graph of the phasor diagram.......................................................................................................38
Figure 3-7 Minimum value of the displacement angle φ with time stamp .....................................................38
Figure 3-8 Value table for the phasor diagram..............................................................................................38