Operator control
8.1 Device interface
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
99
Navigation through the views
Navigation through the measured variables, menus and device settings is assigned
throughout to the function keys F1 and F4:
● F1
: Cancels the last operator action. Returns from display of the device settings to
display of the menu.
● F4
: Calls the main menu.
● F4
: Calls the selected menu entry.
● F4
: Opens edit mode of the device setting.
The figure below shows the navigation paths. The display of the measured variables is the
starting point and end point of the navigation. Repeated pressing of F1 returns you to the
display of the measured variables.
Please note that additional functions are assigned to F4.
F4
: Permanently saves the last set value and returns from edit mode to display mode.
If no editing is intended, the key closes the display and returns to the menu selection.
F4
: Is an ON/OFF switch.
To Next Page
Loading...
