7 Operation at Use of a PC
7.3 Configuration of the Device
147SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
7.3.5.6 Recording Parameters
Default Settings and Setting Ranges
To change the recording parameter settings, proceed as follows:
✧ In the navigation window of the Recording and Reporting menu click Recording parameters.
Figure 7-42 Configure Tab, Recording Parameters Input/Output Window (Excerpt)
✧ Select the parameter in the list box according to Table 7-16.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
NOTE
Power Quality Report describes the output of the power quality report.
Table 7-16 Reporting Parameters
Parameter Default Setting Setting Range
Start record option Start next 10th minute Start next minute
Start next 10th minute
Start immediately
Start next hour
Start next day
Start time - Display of the start time according to the settings
of the Date/time format, see Device and
Language.
Recording status - not settable
Recorder status display started or recorder
stopped
To Next Page
Loading...
