Configuring the operating system
6.9 Backup and restore with the memory card
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
105
3. The data to be restored is checked.
The following messages are displayed in sequence during the check:
– "Starting Restore"
– "Checking data".
4. When the data has been checked, the following prompt for confirmation is displayed:
"You are starting RESTORE now. All files (except files on storage cards) and the registry
will be erased. Are you sure? "
At this point you can abort the restore if required in order to prevent the data on the HMI
device from being deleted.
5. Start to restore the data by selecting "Yes".
The following messages are displayed in sequence during the restore:
– "Deleting files on flash"
– "Restore CE Image"
A progress bar shows the status of the restoration of the Windows CE image.
6. After successful restoration of the Windows CE image, the following message is
displayed: "Restore of CE Image is finished. The device will be rebooted now. Don`t
remove the storage card."
Acknowledge this message.
7. The HMI device starts. The operating system boots, opening the "Loader" and "Restore"
dialog in sequence.
8. The restore process is resumed. All data stored on the flash file system is restored.
Afterwards the following message is displayed: "Restore succesfully finished. Press ok,
remove your storage card and reboot your device."
Remove the memory card.
Acknowledge this message.
9. The HMI device starts.
The data from the memory card is now on the HMI device.
To Next Page
Loading...
