Siemens SIMATIC HMI Mobile Panel 277 RO - 4.6 Switching on and testing the HMI device

Mounting and connecting
4.6 Switching on and testing the HMI device
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
57
4.6
Switching on and testing the HMI device
Procedure
Proceed as follows:
1. Switch on the power supply.
The display lights up after power is switched on. A progress bar is displayed during
startup.
If the HMI device does not start, it is possible that the wires on the terminal block have
been crossed. Check the connected wires and change the connections if necessary.
At the end of the delay time, the RemoteOperate Client software starts.
Result
The server selection list is displayed.