Siemens SIMATIC HMI Mobile Panel 277 RO - Restore from the Memory Card

Configuring the operating system
6.9 Backup and restore with the memory card
Mobile Panel 277 RO
104 Operating Instructions, 10/2015, A5E36824256-AA
6.9.2
Restore from the memory card
Introduction
A restore operation deletes the old data from flash memory of the HMI device on
confirmation. The data stored on the memory card is then copied to the internal flash
memory.
CAUTION
All data on the HMI device will be deleted during a restore operation. Existing licenses are
retained.
Requirements
The memory card with the backup is inserted in the HMI device.
You have opened the "Backup/Restore" dialog with the "Backup/Restore" icon.
①
Button for backup to memory card
②
Button for restore from memory card
Procedure
Proceed as follows:
1. Select "RESTORE" to start Restore.
The HMI device checks the memory card.
2. If no memory card is inserted in the card slot of the HMI device or if the memory card is
damaged:
– The following warning is displayed:
"Storage card couldn't be detected. Try restore again? Insert storage card and Press
'OK' or abort restore with 'CANCEL'."
– Replace the defective memory card and restart Restore with "OK".