Maintenance and care
9.3 Spare parts and repairs
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
125
You have successfully installed the operating system and the RemoteOperate Client
application on the HMI device.
Connecting a PC (Page 56)
Configuring the data channel (Page 96)
Spare parts and repairs
Repairs
In case of repair, the HMI device must be shipped to the Return Center in Fürth. Repairs
may only be carried out at the Return Center in Fürth.
The Mobile Panel 277 RO HMI device is covered by the conditions of repair and return of
equipment, as follows:
1. You return the defective device to the A&D returned goods center. The address is:
Siemens AG
Industry Sector
Returns Center
Siemensstr. 2
90766 Fürth
Germany
2. After it has been repaired, the device is returned to you. A new device will not be supplied
in exchange.
Depending on the work necessary to repair the device, the Center may decide to give you a
credit note. In this case, it is your responsibility to order a new device.
For additional information, refer to the Internet at Spare parts and repairs
(http://support.automation.siemens.com/WW/view/en/16611927
).
Accessories (Page 12)
Due to the low levels of pollutants in the HMI devices described in these Operating
Instructions, they can be recycled. For environment-friendly recycling and disposal of your
old equipment, contact a certified disposal facility for electronic scrap.
To Next Page
Loading...
