Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
39
Checking the package contents
Check the package contents for visible signs of transport damage and for completeness.
install parts damaged during shipment. In the case of damaged parts, contact your
The documentation belongs to the HMI device and is required for subsequent
commissioning. Retain all enclosed documentation for the entire service life of the HMI
device. You must pass on the enclosed documentation to any subsequent owner or user of
the HMI device. Make sure that every supplement to the documentation that you receive is
stored together with the operating instructions.
Mounting the connection box and wall-mounting bracket
Requirements
The following are required for mounting:
● Three M5 cylinder head screws for the wall-mounting bracket of the HMI device
● Four M4 cylinder head screws for the connection box
If the HMI device is to be operated while hooked into the wall-mounting bracket, ensure that
the connecting cable is long enough.
Procedure for mounting the wall-mounting bracket
Note
In order to ensure that the HMI device can be hooked in securely, select a vertical surface or
one inclined slightly to the rear as the mounting surface.
For HMI device with STOP button:
device can fall down if it is not securely hooked in. In the process the STOP button
might be triggered unintentionally, thus causing the machine or system to stop.
To Next Page
Loading...
