Configuring the operating system
6.3 Changing settings for operation
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
81
Proceed as follows:
1. Activate the "Enable character repeat" check box to enable the character repeat.
2. Use the buttons to set the delay and rate of the character repeat. You can also use the
slider control for this.
3. Verify your settings.
– Touch the test field. The screen keyboard opens.
– Move the screen keyboard as needed.
– Touch any character and keep it pressed.
– Check the implementation of the character repetition and the rate of the character
repetition in the test field.
– Correct your setting if necessary.
4. Confirm your entries.
The dialog closes.
The character repeat for the screen keyboard has been altered.
Setting the double-click
Introduction
You can start applications in the Control Panel and in Windows CE with a double-click. A
double-click corresponds to two brief touches in sequence.
In the "Mouse Properties" dialog box, you can set the time interval between the two touches
of the touch screen.
You have opened the "Mouse Properties" dialog with the "Mouse" icon.
To Next Page
Loading...
