Siemens SIMATIC HMI Mobile Panel 277 RO - USB;PPI Cable; Protective Foil; Touch Pens; Memory Card

Overview
1.3 Accessories
Mobile Panel 277 RO
16 Operating Instructions, 10/2015, A5E36824256-AA
1.3.6
USB/PPI cable
You need the cable to update the operating system by resetting to factory settings via the
USB port of the configuration PC. Connect the PC/PPI cable to the RS 485 port of the HMI
device.
Note
Use a USB/PPI cable, version
5 or higher. The version is printed on the cable: For example,
"E
-Stand 5" corresponds to version 5.
The USB/PPI cable is not included with the HMI device. The cable is available under article
number 6ES7 901-3DB30-0XA0.
1.3.7
Protective foil
The protective foil prevents the touch screen from being scratched or soiled.
The protective foil kit is not included with the HMI device. The protective foil kit contains 10
protective foils and has the following article numbers:
● 6AV6671-5BC00-0AX0 for Mobile Panel 277 8"
● 6AV6645-7AB15-0AS0 for Mobile Panel 277 10"
1.3.8
Touch pens
The touch pens make it easier to operate the touch screen.
The touch pen set is not included with the HMI device. The touch pen set contains 5 pens
and is available under article number 6AV6645-7AB14-0AS0.
1.3.9
Memory card
You can use a memory card to back up data from the HMI device and to copy data onto the
HMI device. Only use the SD memory cards or multimedia cards tested and released by
Siemens.
A memory card is not included with the HMI device. The memory card can be ordered using
the Siemens online catalog. For additional information, refer to the Internet at Industry Mall
(https://mall.industry.siemens.com
).