Siemens SIMATIC HMI Mobile Panel 277 RO - 7.3 Changing the server

Using RemoteOperate Client
7.3 Changing the server
Mobile Panel 277 RO
114 Operating Instructions, 10/2015, A5E36824256-AA
7.3
Changing the server
Requirements
● The HMI device is connected as a client to a server.
Procedure
Proceed as follows:
1. Press the touch screen until the RemoteOperate toolbar is displayed.
If you have operator authorization you can, as an alternative, click the traffic lights.
Note
Setting the time to display the toolbar
The length of time you need to press the touch screen before the RemoteOperate toolbar
is displayed is defined in the "roServer.ini" file.
2. Close the connection to the server using the button.
The server selection list is displayed:
3. Connect to a different server. Follow the instructions in the "Connecting a client" section.
Result
You have connected to a different server.