Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
73
Configuring the operating system
The following figure shows the Loader.
The Loader buttons have the following functions:
● Press the "Transfer" button to set the HMI device to "Transfer" mode.
The transfer mode can only be activated when at least one data channel has been
enabled for the transfer.
● Press the "Start" button to start the RemoteOperate Client application.
If you do not execute a command, RemoteOperate Client starts automatically after the
delay time set in the Control Panel.
● Press the "Control Panel" button to open the HMI device Control Panel.
You can change various settings in the Control Panel, for example the transfer settings.
To Next Page
Loading...
