Siemens SIMATIC HMI Mobile Panel 277 RO - Displaying Information about the HMI Device

Configuring the operating system
6.5 Changing HMI device settings
Mobile Panel 277 RO
92 Operating Instructions, 10/2015, A5E36824256-AA
6.5.6
Displaying information about the HMI device
Introduction
You will need the device-specific information if you contact A&D Technical Support.
Requirements
You have opened the "OP Properties" dialog box, "Device" tab, by touching the "OP"
icon.
①
HMI device name
②
Version of the HMI device image
③
Version of the boot loader
④
Boot loader release date
⑤
Size of the internal flash memory in which the HMI device image are stored
⑥
MAC address of the HMI device
⑦
Button for restarting the HMI device
Procedure
Proceed as follows:
1. The device-specific information is displayed in the "Device" tab.
2. Close the dialog when the information is no longer required.
Note
The size of the internal flash memory does not correspond to the available application
memory.