Siemens SIMATIC HMI Mobile Panel 277 RO - Using Memory Cards

Operator controls and displays
5.1 Operator controls and displays on the Mobile Panel 277 RO
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
67
5.1.4
Using memory cards
Requirements
The terminal compartment of the Mobile Panel 277 RO is open.
①
Slot
②
Memory card symbol
③
Velcro strip for fastening the memory card
Procedure for inserting a memory card
Proceed as follows:
1. Remove the Velcro strip.
2. Insert the memory card into the slot.
Pay attention to the memory card symbol when inserting the memory card. An arrow on
the memory card indicates the front side and the direction of insertion. When the memory
card is correctly inserted into the slot, it stands approx. 3mm proud of the slot.
3. Close the Velcro strip.
Procedure for unplugging a memory card
Proceed as follows:
1. Remove the Velcro strip.
2. Pull the memory card out of the slot.
3. Deposit the memory card in a safe place.