Siemens SIMATIC HMI Mobile Panel 277 RO - Wall-Mounting Bracket; PC;PPI Cable

Overview
1.3 Accessories
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
15
1.3.4
Wall-mounting bracket
The wall-mounting bracket provides a safe hold for the Mobile Panel 277 when used in
stationary mode.
①
Hook for the grip on the HMI device
②
Screw flange
The wall-mounting bracket is not included with the HMI device. The wall-mounting bracket is
available under the article number 6AV6574-1AF04-4AA0.
1.3.5
PC/PPI cable
You need the cable to update the HMI device image via the RS 232 serial interface of the
configuration PC. You can also use the cable for data transfer. Connect the PC/PPI cable to
the RS 485 port of the HMI device.
Note
If the conne
ction fails during the operating system update, set the system to a lower bit rate.
If you use a higher bit rate, you must use the PC/PPI cable version 3 or higher. The version
is printed on the cable: For example, "E
-Stand 3" corresponds to version 3.
The PC/PPI cable is not included with the HMI device. The cable is available under article
number 6ES7 901-3CB30-0XA0.