Mounting and connecting
4.6 Switching on and testing the HMI device
Mobile Panel 277 RO
58 Operating Instructions, 10/2015, A5E36824256-AA
Switching off the HMI device
Quit the RemoteOperate Client software by pressing the button before switching off
the HMI device.
You have the following options for switching off an HMI device with no rechargeable battery:
● Switch off the power supply.
● Pull out the connecting cable from the connection box.
Note
Recovery time
Wait for approximately one second after you have removed the connecting cable from the
connection box before you plug the connecting cable back into the connection box.
Wait approximately one second after switching off the power supply before you switch i
t
After power failures lasting less than one second the connecting cable has to be
disconnected.
If the HMI device is fitted with a rechargeable buffer battery, wait until the HMI device has
switched off.
An HMI device with a rechargeable battery will switch into standby mode first. After around
10 minutes, when the rechargeable battery has discharged, the HMI device will switch off.
Setting the delay time (Page 95)
To Next Page
Loading...
