Using RemoteOperate Client
7.2 Connecting a client
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
111
2. Connect the client to the selected server using the button.
While the client is trying to connect to the server, the following message is displayed on
your HMI device:
Note
Response to a network fault
If a transient or long
-term network fault occurs, the client repeatedly tries to establish a
connection to the server. You can abort this repeated attempt to establish a connection
with the
button.
Once a connection to the server has been established, the following options are available:
● The server grants you access. The project running on the server is displayed. Depending
on your authorization, you can either monitor or operate the project on the server.
● The server grants you access. The Windows desktop of the server is displayed. If you
have operator authorization, you can launch your project via the appropriate desktop
icon.
● The server does not grant you access. The following message is displayed on your HMI
device:
You can abort the attempt to establish a connection using the button.
Once the server has rejected your access attempt, your client will remain unauthorized
until the server explicitly grants you access.
To Next Page
Loading...
