Safety instructions and general notes
2.10 Transport and storage conditions
Mobile Panel 277 RO
32 Operating Instructions, 10/2015, A5E36824256-AA
Note
In the following cases, ensure that no moisture can settle on or in the HMI device (dew):
Transportation of the HMI device in low temperatures
Under extreme temperature variations
The HMI device must have acquired room temperature before it is put into operation. Do not
expose the HMI device to direct radiation from a heater in order to warm it up. If dewing has
developed, wait approximately four hours until the HMI device has dried completely before
switching it on.
The following points must be adhered to in order to ensure fault-free and safe operation of
the HMI device:
● Proper transportation and storage
● Proper installation and mounting
● Careful operation and maintenance
The warranty for the HMI device will be deemed void if these stipulations are not heeded.
To Next Page
Loading...
