Siemens SIMATIC HMI Mobile Panel 277 RO - Page 4

Preface
Mobile Panel 277 RO
4 Operating Instructions, 10/2015, A5E36824256-AA
Associated documents
Additional information on the RemoteOperate V4 software is available in the
RemoteOperate V4 programming manual.
Pictures
The HMI device is sometimes shown in the form of photographs in these operating
instructions. The photographs of the HMI device may differ slightly from the factory state of
the HMI device.
Conventions
The following designations for hardware and software are used in this manual:
Designation
Meaning
RemoteOperate Server
The RemoteOperate Server software package
RemoteOperate Client The RemoteOperate Client software package
RemoteOperate
The RemoteOperate software package (Server and Client)
Server
A system on which the RemoteOperate Server software is installed or runs.
Client, HMI device
A system on which the RemoteOperate Client software package runs.
The following text notation will facilitate reading this manual:
Notation
Scope
"Add figure"
• Terminology that appears in the user interface, for example dialog
names and buttons.
• Required inputs, for example, an IP address.
• Path information
"File > Edit" Operating sequences, for example, menu commands, shortcut menu
commands.
<F1>, <Alt + P>
Keyboard actions
Please observe notes labeled as follows:
Note
Notes containing important information about the product and its use or a specific section of
the documentation to which you should pay particular attention.
Registered trademarks
● HMI
®
● SIMATIC
®
● SIMATIC HMI
®
Third parties using for their own purposes any other names in this document which refer to
trademarks might infringe upon the rights of the trademark owners.