Mounting and connecting
4.4 Connecting the connection box
Mobile Panel 277 RO
50 Operating Instructions, 10/2015, A5E36824256-AA
Procedure for plugging in the connector
Proceed as follows:
1. Retract the outer sleeve on the plug connector.
2. Plug the connector with retracted outer sleeve into the socket of the connection box.
3. Now release the outer sleeve.
The outer sleeve glides automatically in the direction of the connection box and thereby
locks the connector.
Procedure for removing the connector
Proceed as follows:
1. Retract the outer sleeve on the plug connector.
2. Pull the connector with retracted outer sleeve out of the socket of the connection box.
If you do not intend to use the HMI device with a different connection box, place the HMI
device securely in its wall-mounting bracket.
To Next Page
Loading...
