Mounting and connecting
4.5 Connecting the Mobile Panel 277 RO
Mobile Panel 277 RO
52 Operating Instructions, 10/2015, A5E36824256-AA
Cross-head screwdriver, size 2
Proceed as follows:
1. Unscrew the six screws approximately 1 cm out of the cover.
The cover is designed in such a way that the screws cannot fall out. Therefore, do not
screw the screws out further than 1 cm. The screws can then be removed together with
the cover.
2. Put the cover with the screws to one side.
Note on closing:
1. Place the sealing plugs into the cable inlets which are not used.
To Next Page
Loading...
