Siemens SIMATIC NET SCALANCE W700 User Manual

Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
128 Configuration Manual, 08/2018, C79000-G8976-C267-13
Description
●
Severity Filters
You can filter the entries in the table according to severity. To display all the entries,
enable or disable all parameters.
Note
For each severity, a maximum of 400 entries in the table are possible. If the maximum
number of entries is reached for a severit
y, the oldest entries of this severity are
overwritten in the table. The table remains permanently in the memory.
– Info
Information
When this parameter is enabled, all entries of the category "Info" are displayed.
– Warning
Warnings
When this parameter is enabled, all entries of the category "Warning" are displayed.
– Critical
Critical
When this parameter is enabled, all entries of the category "Critical" are displayed.
The table has the following columns:
●
Restart
Counts the number of restarts since you last reset to factory settings and shows the
device restart after which the corresponding event occurred.
●
System Up Time
Shows the time the device has been running since the last restart when the described
event occurred.
●
System Time
Shows the date and time when the described event occurred.
●
Severity
Shows the severity of the message.
●
Log Message
Displays a brief description of the event that has occurred. You will find the list of possible
messages in Appendix D (Page 447) of the configuration manual.
If the system time is set, the time is also displayed at which the event occurred.

Siemens SIMATIC NET SCALANCE W700 Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W700
Category	Wireless Access Point
Language	English