Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
380 Configuration Manual, 08/2018, C79000-G8976-C267-13
To display a new server, follow the steps below:
1. In the relevant row, enter the following data in the input boxes:
– IP address or FQDN name of the RADIUS server.
– Port number of the input port
– Password
– Confirmation of the password
– Maximum number of transmission retries
– Primary server
2. Click the "Set Values" button.
1. In the relevant row, enter the following data in the input boxes:
– Server IP address
– Port number of the input port
– Password
– Confirmation of the password
– Maximum number of transmission retries
– Primary server
2. Click the "Set Values" button.
Repeat this procedure for every server whose entry you want to modify.
Client RADIUS Supplicant
Client Supplicant
On this WBM page, you configure the settings for the RADIUS authorization of the client.
Note
This WBM page is only available in client mode.
Note
Dot1X user name and Dot1X user password
With WPA (RADIUS), WPA2 (RADIUS), EAP
-TLS, EAP-TTLS and PEAP the Dot1X user
e and the Dot1X user password must be configured.
With the setting "Auto" either the certificate must be loaded or the Dot1X user name and the
Dot1X user passport must be configured.
To Next Page
Loading...
Need help?
General
