Siemens SIMATIC NET SCALANCE W700 User Manual

Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
214 Configuration Manual, 08/2018, C79000-G8976-C267-13
Description
The table has the following columns:
●
Client Type
Select the client type for which you want to make settings:
–
E-mail
Sending system event messages by e-mail
–
Log Table
Entry of system events in the log table
–
Syslog
Entry of system events in the Syslog file
–
WLAN Authentication Log
Entry of system events in the WLAN authentication log
●
Severity
Select the required level. The following settings are possible:
–
Critical
System events are processed as of the severity level "Critical".
–
Warning
System events are processed as of the severity level "Warning".
–
Info
System events are processed as of the severity level "Info".
Procedure
Follow the steps below to configure the required level:
1. Select the required values from the drop-down lists of the second table column after the
client types.
2. Click the "Set Values" button.
6.5.10
SMTP Client
Network monitoring with e-mails
The device provides the option of automatically sending an e-mail if an alarm event occurs
(for example to the network administrator). The e-mail contains the identification of the
sending device, a description of the cause of the alarm in plain language, and a time stamp.
This allows centralized network monitoring to be set up for networks with few nodes based
on an e-mail system. When an e-mail error message is received, the WBM can be started by
the Internet browser using the identification of the sender to read out further diagnostics
information.

Siemens SIMATIC NET SCALANCE W700 Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W700
Category	Wireless Access Point
Language	English