Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
130 Configuration Manual, 08/2018, C79000-G8976-C267-13
The table has the following columns:
●
Counts the number of restarts since you last reset to factory settings and shows the
device restart after which the corresponding event occurred.
●
Shows the time the device has been running since the last restart when the described
event occurred.
●
Shows the date and time when the described event occurred.
●
Shows the severity of the message.
●
Displays a brief description of the event that has occurred. You will find the list of possible
messages in Appendix D (Page 447) of the configuration manual.
If the system time is set, the time is also displayed at which the event occurred.
If a fault occurs, it is shown on this page. On the device, faults are indicated by the red fault
LED lighting up.
Internal faults of the device and faults that you configure on the following pages are
indicated:
● "System > Events"
● "System > Fault Monitoring"
The calculation of the time of a fault always begins after the last system start. If there are no
faults present, the fault LED switches off.
To Next Page
Loading...
Need help?
General
