Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
187
parameter in "Layer 2 > VLAN > General". You can only select VLANs that have already
been configured.
Note
Changing the Agent VLAN ID
If the configuration PC is connected directly to the device via Ethernet and you change
the agent VLAN ID, the device is no longer reachable via Ethernet following the change.
●
Shows the MAC address of the device. The MAC address is linked to the hardware and
cannot be modified.
1. In the input boxes, enter the IP address, subnet mask and the default gateway.
2. Select the assigned VLAN ID from the "Agent VLAN ID" drop-down list. If the drop-down
list cannot be enabled, check whether the "Base Bridge Mode" parameter is set to "802.1
Q VLAN Bridge". You configure the parameter in "Layer 2 > VLAN > General".
3. Click the "Set Values" button.
Agent IPv6
Configuration of the IP addresses
On this page, enable IPv6 on the management VAN. This VLAN interface is also called an
IPv6 interface. An IPv6 interface can have several IPv6 addresses.
To Next Page
Loading...
Need help?
General
