Siemens SIMATIC NET SCALANCE W700 User Manual

Configuring with Web Based Management
6.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
188 Configuration Manual, 08/2018, C79000-G8976-C267-13
Description
The page contains the following:
●
Interface
Shows the VLAN interface on which IPv6 will be enabled.
●
IPv6 Enable
Enable or disable IPv6 on the interface. When you enable the setting and accept it, the
link local address is created automatically.
●
IPv6 Address
Enter the IPv6 address. The entry depends on the selected address type.
●
Prefix Length
Enter the number of left-hand bits belonging to the prefix
●
IPv6 Address Type
Select the address type:
– Unicast
– Link Local: IPv6 address is only valid on the link.
●
Address Configuration
Specify the mechanism for the address configuration:
– Automatic (default)
The IPv6 address is created using a stateless mechanism or a stateful mechanism.
– DHCPv6
Status dependent: Obtains the IPv6 address and the configuration file from the
DHCPv6 server.
– SLAAC (Stateless Address Auto Configuration)
Stateless autoconfiguration using NDP (Neighbor Discovery Protocol)
– Static
Enter a static IPv6 address.
●
DHCPv6 Rapid Commit
When enabled the procedure for the IPv6 address assignment is shortened. Instead of 4
DHCPv6 messages (SOLICIT, ADVERTISE , REQUEST, REPLY) only 2 DHCPv6
messages (SOLICIT, REPLY) are used. You will find further information on the messages
in RFC 3315.
The table has the following columns:
●
Select
Select the check box in the row to be deleted.
●
Interface Name
Shows the name of the VLAN interface.

Siemens SIMATIC NET SCALANCE W700 Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W700
Category	Wireless Access Point
Language	English