Siemens SIMATIC NET SCALANCE W700 User Manual

Configuring with Web Based Management
6.4 "Information" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
157
The table has the following columns:
●
Radio
Shows the available WLAN interfaces in this column.
●
Type
Shows the mode of the WLAN interface.
●
SSID
Shows the SSID of the access point.
●
BSSID
Shows the MAC address of the access point.
●
System Name
Shows the system name of the SCALANCE W700-Geräts. The entry depends on the
access point. Not all access points support this parameter.
●
Channel
Shows the channel over which the client communicates with the access point.
●
Signal Strength [dBm]
Shows the signal strength of the client in bBm.
●
Signal strength [%]
Shows the signal strength of the client as a percentage.
●
Age [s]
Shows the time that has elapsed since the last access point activity.
●
Security
Shows which authentication method is used.
– If the authentication method "Open System + Encryption" or "Shared Key" is used, the
"Encrypted (WEP/AES)" is displayed for both authentication methods.
– If iPCF, iPCF-HT or iPCF-MC mode is enabled on the WLAN interface, the following is
displayed depending on the encryption status:
iPCF Encrypted (AES): Encryption is enabled.
iPCF authentication: Encryption is disabled.
●
WLAN Mode
Shows the transmission standard. If DFS is activated, the transmission standard
"802.11h" is not shown additionally but only the configured transmission standard
"802.11a" or "802.11n".

Siemens SIMATIC NET SCALANCE W700 Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W700
Category	Wireless Access Point
Language	English