Configuring with Web Based Management
6.6 "Interfaces" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
311
6. Change to one of the following menu items to call up the result of the recording:
– System > Load&Save > HTTP
Click the "Save" button in the "WLANSigRec" table row to save the file
"signal_recorder_SCALANCE_W700.zip" in the file system of the connected PC.
– System > Load&Save > TFTP
If necessary, change the file name "signal_recorder_SCALANCE_W700.zip" in the
"WLANSigRec" table row. In the table row "WLANSigRec", select the "Save file" entry
from the drop-down list of the last column and click the "Save Values" button.
7. The ZIP file contains two files with the results of the recording:
– A PDF file: The output is limited to 300 pages.
– A CSV file: Complete listing of the recording.
Measurement results
PDF file
The PDF file contains a graphic representation of the course of the effective user data signal
in dBm and the course of the data rate in Mbps. In terms of color, the graphic corresponds to
the appearance in the Web Based Management. If the client changes the access point
(roaming) during the measurement, this is indicated by vertical black bars with a black
square at the tip.
The display is divided into two areas:
● Client
Represents the measurement of the client.
● Access point
Displays the measurement of the access point with which the client is currently
connected. This requires that the setting "Bidirectional Recording" is enabled and that a
firmware version > 6.1 is installed on the access point. The access point sends its data to
a maximum of 3 clients on which signal recorders are running. The access point data is
not displayed on other clients.
If the client has an iPCF-MC connection, the user signal of the management channel is
shown with an additional black line.
To Next Page
Loading...
Need help?
General
