Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
399
●
Enter the IP address or the network address to which the rule will apply.
– If you use the IPv4 address 0.0.0.0, the settings apply to all IPv4 addresses.
– If you use the IPv6 address :: the settings apply to all IPv6 addresses.
●
Subnet Mask / Prefix Length
Enter the subnet mask or the prefix length.
The subnet mask 255.255.255.255 is for a specific IPv4 address. If you want to allow a
subnet, for example a C subnet, enter 255.255.255.0. The subnet mask 0.0.0.0 applies to
all subnets.
The table has the following columns:
●
Select the check box in the row to be deleted.
●
Shows the number of the rule. If you click the "Create" button, a new row with a unique
number is created.
●
Shows the IP address.
●
Subnet Mask / Prefix Length
Shows the subnet mask or the prefix length.
●
Only available if 802.1Q VLAN Bridge is set for "Layer 2 > VLAN > General".
Enter the number of the VLAN in which the device is located. The station can only access
the device if it is located in this configured VLAN. If this input box remains empty, there is
no restriction relating to the VLANs.
●
Specify whether the station (or the IP address) accesses the device using the SNMP
protocol.
●
Specify whether the station (or the IP address) accesses the device using the TELNET
protocol.
●
Specify whether the station (or the IP address) accesses the device using the HTTP
protocol.
●
Specify whether the station (or the IP address) accesses the device using the HTTPS
protocol.
●
Specify whether the station (or the IP address) accesses the device using the SSH
protocol.
●
Specify whether the station (or the IP address) accesses the device via this port.
To Next Page
Loading...
Need help?
General
