Siemens SIMATIC PCS 7 User Manual

Message log
● The message log only shows errors and warnings or outputs from the EDD.
8.3.3 Value comparison
8.3.3.1 Value comparison
Starts the comparison of device parameters.
You make the settings for comparing device parameters in the "Value Comparison" dialog
box (Page 168).
See also
Parameter table (Page 61)
8.3.3.2 "Value Comparison" dialog box
Purpose
You start the comparison of device parameters in this dialog box. The value comparison is
always based on the device parameter values saved in the project.
The device parameter values saved in the project can be compared with the following data
types:
● Offline data
Device parameter values saved in the project.
● Online data
Parameter values currently saved in the device.
Comparisons
The following comparisons are possible:
● Comparison of the parameters of one device (offline/online parameter comparison)
● Comparison of the parameters of two devices:
– Offline/online parameter comparison
Menus and dialog boxes in SIMATIC PDM
8.3 "Device" menu
Help for SIMATIC PDM (V8.2)
168 Operating Manual, 02/2014, A5E33203676-AA

Siemens SIMATIC PCS 7 Specifications

General

Brand	Siemens
Model	SIMATIC PCS 7
Category	Control Systems
Language	English