● For MODBUS devices:
Select the "MODBUS" folder and press the "Device identification" button
● For HART devices:
Select the "HART" folder and then press the "Device identification" button
Additional information
● Section "Integrating devices into SIMATIC PDM (Page 31)"
7.3.1.4 Integrating a device in HW Config
Below, you will learn how to insert devices in the project using HW Config:
● Inserting a DP device
● Inserting a DP remote I/O system (distributed I/O)
● Inserting a PA device at a DP/PA coupler
● Inserting a PA device at a DP/PA-Link
● Inserting a PA remote I/O system (distributed I/O)
● Inserting a remote I/O system (PROFINET)
Requirement
PROFIBUS DP master system or PROFINET IO system
Options for creating the PROFIBUS DP master system:
● In HW Config:
If the DP master system is not displayed, select the menu command Insert > Master
system at the required PROFIBUS module.
● In the process device network view:
– Open the process device network view in SIMATIC Manager.
– Double-click the "Networks" object in the right window to insert a PROFIBUS DP
network. Select "Networks" in the left window, and select the menu command Insert
New Object > Object in the shortcut menu.
– Click the "Assign Device Type" button.
The "Insert object - Assign device type" dialog box opens.
You can find additional information on this in the section ""Insert Object - Assign Device
Type" dialog box (Page 79)".
– Select the PROFIBUS DP network from the tree structure.
– Click "OK".
The PROFIBUS DP network is inserted.
Note
Representation in HW Config
Objects created in the process device network view are not displayed in HW Config.
Functions
7.3 Device management
Help for SIMATIC PDM (V8.2)
Operating Manual, 02/2014, A5E33203676-AA 81
To Next Page
Loading...
